Apply Mask
This function block allows you to filter out specific parts of an image using a mask image, which should contain black and white patterns. The resulting image will show only the areas defined by the white parts of the mask.
📥 Inputs
Image
The original image that you want to apply the mask to.
Mask
A binary image where white (255) indicates areas to retain from the original image and black (0) indicates areas to remove.
📤 Outputs
Filtered
The output image that shows the result after applying the mask to the original image.
🕹️ Controls
This function block does not have specific controls as it processes the images based on the provided inputs.
🎨 Features
Binary Masking
The block uses a binary mask to selectively filter areas of an image, effectively isolating desired parts.
Real-Time Processing
The mask is applied instantly, allowing users to visualize the results as soon as images are connected.
📝 Usage Instructions
Connect Input Images: Connect the image you wish to filter to the
Image
input and the mask to theMask
input.Run the Block: Evaluate the block. The output will automatically display the filtered image, highlighting only the areas defined by the white parts of the mask.
📊 Evaluation
Upon running, the function block processes both the original image and the mask, producing a new image where only the relevant areas are visible based on the mask.
💡 Tips and Tricks
🛠️ Troubleshooting
Last updated
Was this helpful?